top of page

Configure Assets

To avoid service overages, use caution when modifying the settings or creating new ones

 

Device Data Settings, or DDS, indicate the frequency that the system records and transmits the location of an asset.
 

  • By default, all assets based on the same product use the default settings established for that product

  • Device Data Settings (DDS) vary according to the product to which you are subscribed

 

There are three types of Device Data Settings:

 

 In-Vehicle Tracking (MGS) 

The standard parameter is to record a position every 2 minutes and transmit back to Fleet Complete every 6 minutes.

 

 AT-1000 Asset Tracker 

​The standard parameter is to record a position once every 24 hours when stationary and not attached to a power source or every 4 hours when connected to a power source and/or in motion.

 

 AT1 Asset Tracker 

​The standard parameter is to record a position once every 24 hours

 

HOW TO ADD A DEVICE DATA SETTING

Steps:

  1. From the Tracking screen, click the Menu Bar icon on the top left-hand corner to access then Navigation Panel 

  2. Click the Manage menu item

  3. Click the Devices submenu item. In this example, we will select In-Vehicle Tracking

  4. Click the Add button

  5. Click Proceed




















     

  6. Type the Description of the new Device Data Setting

  7. Type the Recording Frequency parameter (Minimum of

  8. 30 seconds

  9. Type the Transmission Frequency parameter (Minimum of 60 Seconds)

  10. Optionally, Use the slider bar to enable or disable Data Conservation Mode (DCM). If enabled, type in the Transmit Interval when DCM is disabled in minutes

  11. Click the Save button

dds.PNG
NEW DDS.PNG
bottom of page